Simply put - the report seems to hold or cache the results when users interact with the report using the on page slicers. What is Stange is the report show no on page or report level filters in play. Nothing has been selected. Refreshing the report will return the whole data set but if I navigate a way and back then the filters are on again. I will republish the report from desktop and everything will then be as they should (no filters running) but invariably a few hours later the report is being filtered again. Again I will check the report/Page and Viual level filters on the affected page but there is nothing selected.
All memebers are view only users so I can figure out what might be going on. Any ideas?
Note:
1. The reason I think it's the on page slicer is that the other pages don't have the same data filtered.
2. It is connected to SSAS Tabular (don't know why that should make a difference)
All memebers are view only users so I can figure out what might be going on. Any ideas?
Note:
1. The reason I think it's the on page slicer is that the other pages don't have the same data filtered.
2. It is connected to SSAS Tabular (don't know why that should make a difference)